1/2'BSPThread , 12Liter/Min Suction Strainer
Features
Stainless steel mesh
Re-usable
Epoxy bonded joints for compatibility with all fluids
Rugged steel inner support
Nylon fitting/Nylon end caps (210° max)
100~125 mesh from stock
Options
No by-pass or 3 psi by-pass available
Custom sizes and mesh are available upon request
Model: LESF-KH3(No by-pass )
Norminal Flow:12Liter/Min
Pipe Size: 1/2'BSP
OD: 66mm, 3in
Length:100mm,3.94in
Suction Strainer Elements are designed for installation into suction lines of pumps. Extra caution should be taken to ensure that the
suction elements are always mounted below the minimum oil level of the reservoir. Standard models have nominal filtration ratings
of 74 or 125 microns. The suction strainer elements can also be supplied with a bypass valve to reduce high pressure drops caused
by contaminated elements or high viscosity fluids during cold starting. The bypass valve opens at 3 psi. For best results, suction strainer
elements should be sized for clean element pressure drops off no higher than 0.5-.07 psi.
suction Strainer Elements are manufactured using stainless steel wire screen media. Suction strainer elements are only intended to
protect hydraulic pumps against catastrophic failure caused by coarse contaminants. Suction strainer elements should be inspected
and cleaned regularly. Suction strainer elements should not be used as the only filtration elements in a hydraulic system. Pressure filters
and return line filters, with reasonable dirt holding capacity, must be installed to provide protection against component damage caused by
fine contaminants.
Quality assurance
{sval:sql sql='SELECT n_parameter FROM dede_addonarticle WHERE aid = ~aid~ ' } {/sval:sql}
{sval:sql sql='SELECT n_parameter FROM dede_addonarticle WHERE aid = ~aid~ ' } {/sval:sql}
