Product presentation:

The high flow water filter element uses deep fine polypropylene or glass fiber film as the filter material, with a large diameter of 6 inch / 152mm, no center rod, one-way opening, and specially designed liquid flow from the inside to the outside to ensure that all pollutant particles are intercepted inside the filter element. The design of high flow rate obviously reduces the use of filter element and filter in the same flow application occasions, which greatly saves the input cost and labor cost of high flow water filter element.

Product features:

1. the combination of surface filtration and deep filtration, compared with ordinary filter elements, can greatly reduce the number of filter elements, and significantly reduce the size of the supporting shell;

2. The filter layer is made of high efficiency and low resistance material, which can achieve more than 99% ultra-high filtration efficiency and prolong the service life of the filter element;

3. The design of the convenient handle significantly reduces the time to replace the filter element, making the replacement of the filter element simple and portable.

4. the overall polypropylene design and hot melt welding treatment, effectively prevent the end cover from falling off and secondary pollution.

5. The design of the sealing interface reduces the risk of side flow and ensures the sealing and reliability of filtration;

6. folding design, increase the filter area, so that its pressure drop is significantly lower than the ordinary filter element,

7. large diameter design, increase the amount of pollution, prolong the service life, reduce the production cost;

8. equipped with a skeleton, strengthen the use of the filter element in the process of the compression ability;

Product mix:

Filter material: polypropylene (PP)

Skeleton / end cap: polypropylene (PP)

Seal ring: silicone rubber / EPDM / fluoro rubber / nitrile rubber

Product specification: 20 inch / 40 inch / 60 inch

Use of the PH: 1-13

Maximum differential pressure: 2.0Bar

Filter accuracy: 1 μ m, 3 μ m, 5 μ m, 10 μ m, 25 μ m, 50m, 100 μ m

Interface form: plane pressure-in type (other interfaces can be added)

Gasket / sealing ring: silicone rubber, ethylene propylene rubber, nitrile rubber, fluorine rubber

Operational principle:

High flow filter element, large diameter design, efficient filter, high strength support skeleton inside and outside, using multi-layer composite progressive filter material, overall hot melt welding, external sealing ring. Single tributary volume of 50-90 m3/H design, this high flow filter element is suitable for large reverse osmosis pre-filtration and other fields. The new patent for the filter element combined with a 6 / 152 mm large diameter design reduces the number of filters and the case size requirements. A variety of filtration media can also be provided to meet other application requirements.

Applied range:

Common use: the pre-filtration of the RO reverse osmosis system

Chemical / petrochemical industry: all kinds of acids, bases, solvents, cold chiller water, salt water, etc

Power plant: fill water, condensate water, stator cooling water, etc

General industry: all kinds of process fluid, process water, condensate water, cooling water, wastewater treatment, etc

Microelectronics industry: deionized water pre-filtration

Food and beverage industry: process water, etc

Other Related Products：

PP meltblown filter element

Condensate filter element

Wedge mesh filter element